AiM Solo 2 DL Panigale Euro5
AiM Solo 2 DL Panigale Euro5
AiM Solo 2 DL Panigale Euro5
AiM Solo 2 DL Panigale Euro5
AiM Solo 2 DL Panigale Euro5
Plug & Play Kits for Ducati Panigale Euro5
Our CAN Bus capable devices can now communicate with the Ducati Panigale motorbikes of the models V2 and V4 Euro5. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.
In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.
Supported models
| Panigale V2 |
from 2020 |
| Panigale V4 (only Euro5) |
from 2021 |
Channels over CAN-Bus
| Engine speed |
Torque |
| Gear |
Engine brake status |
| Rear speed |
Engine brake setting |
| Front speed |
Wheelie control status |
| Linear acceleration |
Wheelie control setting |
| Lateral acceleration |
Traction control status |
| Angle of inclination |
Traction control setting |
| Roll |
Slip control status |
| Yaw rate |
Slip control setting |
| Water temperature |
Engine status |
| Intake air temperature |
Brake light switch |
| Throttle valve position |
Battery voltage |
| Inclined position |
Throttle grip position |
| Front brake pressure |
|
Installation using the example Solo 2 DL
- Connect the "Connection cable Solo 2 DL forDucati" to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your AiM Solo 2 DL.
- With the software RaceStudio3 you create a new configuration for your AiM Solo 2 DL and select as ECU manufacturer: Ducati and as ECU Model: Panigale V.
- Connect your Solo 2 DL to your PC via WLan.
- Transfer the configuration to the AiM Solo 2 DL.
- You can check the communication via the online mode.