Plug & Play Kits for Ducati Panigale
Our CAN Bus capable devices can now communicate with the Ducati Panigale motorbikes of the models 899, 959, 1199, 1199R, 1299 and Panigale V4. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.
In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.
Supported models
| 899 Panigale |
2013 - 2015 |
| 959 Panigale |
from 2016 |
| 1199 Panigale |
2012 - 2014 |
| 1199R Panigale |
2015 - 2017 |
| 1299 Panigale |
2015 - 2019 |
| Panigale V4 |
2018 - 2020 |
Channels over CAN-Bus
| Engine speed |
Rear speed |
| Throttle valve position 1 |
Throttle valve position 2 |
| Gasgriff |
Water temperature |
| Front Speed |
Intake air temperature |
| Battery voltage |
Brake light switch |
| Clutch switch |
Neutral |
| Oil pressure switch |
Turn indicator right |
| Turn indicator left |
Schalter Mapping |
| High beam |
Airboxdruck |
| Lambda 1 |
Lambda 2 |
| Lambda sensor temperature 1 |
Lambda sensor temperature 2 |
| Lambdadiagnose 1 |
Lambdadiagnose 2 |
| Front brake pressure |
Rear brake pressure |
| Traction control RDC |
Traction control PERC |
| Gear |
Traction control |
| Mapping |
|
Installation using the example Solo 2 DL
- Connect the "Connection cable Solo 2 DL forDucati" to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your AiM Solo 2 DL.
- With the software RaceStudio3 you create a new configuration for your AiM Solo 2 DL and select as ECU manufacturer: Ducati and as ECU Model: Panigale.
- Connect your Solo 2 DL to your PC via WLan.
- Transfer the configuration to the AiM Solo 2 DL.
- You can check the communication via the online mode.