Solo 2 DL Plug & Play Kits for Kawasaki ZX-10R
Our CAN Bus capable devices can now communicate with the Kawaski motorbikes of the models Ninja ZX-10R. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.
In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.
Supported models
| Kawasaki Ninja ZX-10R |
2011 - 2015 |
| Kawasaki Ninja ZX-10R Racing Kit |
2011 - 2015 |
| Kawasaki Ninja ZX-10R |
from 2016 |
| Kawasaki Ninja ZX-10R Racing Kit |
from 2016 |
Channels over CAN-Bus
| Engine Speed |
Power Mode |
| Odometer |
Launch control Mode |
| Water temperature |
Front speed |
| Intake air temperature |
Rear speed |
| Gear |
Wheelie control |
| Clutch switch |
Battery voltage |
| Traction control |
Throttle grip position |
| Engine brake |
Throttle valve |
| Launch control |
Angle of inclination |
| Quick Shift |
|
Installation using the example Solo 2 DL
- Connect the "Connection cable Solo 2 DL for Kawasaki" to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your AiM Solo 2 DL.
- With the software RaceStudio3 you create a new configuration for your AiM Solo 2 DL and select as ECU manufacturer: KAWASAKI and as ECU Model: ZX10R_2016.
- Connect your Solo 2 DL to your PC via WLan.
- Transfer the configuration to the AiM Solo 2 DL.
- You can check the communication via the online mode.