Solo 2 DL Plug & Play Kits for Honda
Our CAN Bus capable devices can now communicate with the Honda motorbikes of the models CBR. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.
In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.
Supported models
| Honda CBR 600RR |
2003 - 2019 |
| Honda CBR 600RR HRC (D11 mmarked ECU) |
2013 - 2015 |
| Honda CBR 1000RR |
2004 - 2016 |
| Honda CBR 1000RR HRC |
2014 - 2016 |
Channel over CAN-Bus
| Engine speed |
Battery voltage |
| Throttle valve |
Speed |
| Water temperature |
Ignition angle |
| Intake air temperature |
Injection time |
| Airbox pressure |
|
|
|
Installation using the example Solo 2 DL
- Connect the "Connection cable Solo 2 DL for Honda" to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your AiM Solo 2 DL.
- With the software RaceStudio3 you create a new configuration for your AiM Solo 2 DL and select as ECU manufacturer: HONDA and as ECU Model: HDS_TAB10.
- Connect your Solo 2 DL to your PC via WLan.
- Transfer the configuration to the AiM Solo 2 DL.
- You can check the communication via the online mode.