Solo 2 DL Plug & Play Kits for Ducati
Our CAN Bus capable devices can now communicate with the Ducati motorbikes of the models 848, 1098 und 1198. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.
In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.
Supported models
| Ducati 848 |
2007 - 2013 |
| Ducati 848 EVO |
2007 - 2013 |
| Ducati 848 EVO Corse |
2007 - 2013 |
| Ducati 1098 |
2007 - 2009 |
| Ducati 1098 S |
2007 - 2009 |
| Ducati 1098 S Tricolore |
2007 - 2009 |
| Ducati 1098 R |
2007 - 2009 |
| Ducati 1198 |
2009 - 2011 |
| Ducati 1198 S |
2009 - 2011 |
| Ducati 1198 S Corse |
2009 - 2011 |
| Ducati 1198 R Corse |
2009 - 2011 |
| Ducati 1198 SP |
2009 - 2011 |
Channels over CAN-Bus
| Engine speed |
Speed |
| Throttle valve position |
Water temperature |
| Air intake temperature |
|
Installation using the example Solo 2 DL
- Connect the "Connection cable Solo 2 DL for Ducati" to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your AiM Solo 2 DL.
- Lay the connection cable from the front to where your passenger would normally be.
- There, under the seat, you will find a black 4-pin connector. Remove the protective cover of the plug..
- Connect this black plug to our white one on the connection cable.
- Use the RaceStudio3 software to create a new configuration for your Solo 2 DL and select as ECU Manufacturer Ducati and selsect as ECU Model: 1098/S.
- Connect your Solo 2 DL to your PC via WLan.
- Transfer the configuration to the AiM Solo 2 DL.
- You can check the communication via the online mode.